Home     In General     Products      Company Profile      Contents       Contact

Heating Tapes
Heating Mantles
Heating Hoses
Temperature Regulators
Special Heatings

wpe15.jpg (2281 Byte)

Temperature Regulators

Analogous (Single-Channel) Desktop Regulators

HT 30

Versatile Laboratory Regulator with Electronic Outlet for up to 10 A

If a controlled and careful heating-up is required, the combination of power controller and PD temperature regulator produces reliable results.

With this electronic power controller, the nominal power can be reduced from 100 % to 0 and can thus be adjusted to individual power requirements. This is especially important at low temperatures when too much power would cause an overswing of the control circuit.

The digital set­point adjustment of the temperature regulator has an accuracy of 1 °C. Due to the adjustable control amplifier, the regulator can be adapted to the respective controlled system. Therefore, the accuracy can be kept even if the controlled systems are very special or different.

When the sensor connection or the sensor element itself is broken, the device turns off immediately. A control lamp indicates the failure.

With an apparatus clamp, the regulator can be mounted on a stand. The clamp can be fixed at the rear of the device.

Linear voltage output: For the connection to a recording instrument, a digital display, etc. ..., the regulator has a linearized voltage output. The device has a diode plug socket.

Technical Data:

two-position-regulator
control system: P-PD
power control: triac
switching power at 230 V~: 2300 W
main switch: double-pole, luminous
degree of accuracy: 1 %
servo amplifier: 0.5 ... 5 %
instantaneous value tap: 10 mV
power control: 0 ... 100 %
safety class: I
protection category: IP 30 (DIN 40 050)
interf. suppression: N (VDE 0875)
mains cable: 1.5 m
case dimensions: 75 x 115 x 145 mm
case material: coated steel / aluminum
order no. switching power sensor
06 30 01 10 A NiCr-Ni (K)
06 30 02 10 A Pt 100

wpe1.jpg (2373 Byte)

HT 31

Versatile Laboratory Regulator with Electronic Outlet for up to 16 A

The laboratory regulator HT 31 has all technical advantages of the HT 30, but additionally allows switching power up to 16 A.

Technical Data:

two-position-regulator
control system: P-PD
power control: triac
switching power at 230 V~: 3600 W
main switch: double-pole, luminous
degree of accuracy: 1 %
servo-amplifier: 0.5 ... 5 %
instantaneous value tap: 10 mV/°C
power control: 0 ... 100 %
safety class: I
protection category: IP 30 (DIN 40 050)
interf. suppression: N (VDE 0875)
main cable: 1.3 m
case dimensions: 74 x 161 x 136 mm
case material: coated steel / aluminum
order no. switching power sensor
06 31 01 16 A NiCr-Ni (K)
06 31 02 16 A Pt 100

wpe1.jpg (2373 Byte)

Actual Value Display for HT 30 / HT 31

Technical Data:

display: LCD
case dimensions: 60 x 80 x 20 mm
case material: plastic
connection: with 3-pole socket to HT 30 / HT 31
length connection line: 1 m
order no.
06 31 90

Home      In General      Products       Company Profile       Contents       Contact

Please send your E-Mail to: info@Horst.de
Copyright ©
1997-2005 Horst GmbH. All rights reserved. Terms of Use.
Last change: 2005-02-25